Irrigation Equipment Directory

Corner Systems and Odd-Shaped Fields

A plain pivot leaves corners dry in square fields. Corner arms, end guns and partial circle settings add coverage, but each also spreads water thinner across more ground.

Why it matters

Dry corners can be a fifth of a quarter section. Adding coverage raises revenue only if flow, pressure and power stay adequate, so the math on acres and gpm per acre must come first.

Step by step

  1. Map the field and the circle, and mark uncovered corners, obstacles, ditches and fence lines.
  2. Measure uncovered acres, and decide whether a corner arm, end gun or a separate small system fits best.
  3. Check flow per acre before and after, dividing system gpm by total irrigated acres.
  4. Check pump and pressure capacity, since corner arms and guns need added pressure and electrical load.
  5. Program stop zones and sector settings so you do not water roads, buildings or neighbors.

What good looks like

A good result adds useful acres at a flow per acre still meeting crop needs, with pressure steady and no spray on roads or neighbors' ground, and with clear programming.

Worked example

Illustrative: a 160 acre square has a 125.66 acre circle, leaving 34.34 acres dry. A corner arm adds 14 acres, giving 139.66, or 87.3 percent of the field. At a fixed 800 gpm, flow per acre drops from 6.37 to 5.73, about 10 percent less.

Common mistakes to avoid

  • Adding corner coverage without checking flow per acre.
  • Ignoring the extra power draw of end guns and booster pumps.
  • Watering roads, ditches and adjacent fields with uncontrolled corner spray.
  • Forgetting that corner arms add maintenance and more crop-damaging wheel tracks.

Safety, legal and compliance notes

Overspray onto roads or neighbors may raise liability, and buried or overhead utilities near corners pose hazards. Call your local utility locating service before digging, and check local rules for spray limits.

What to record

Keep a dated equipment file: purchase date and cost, model and serial numbers, nozzle and sprinkler package charts, pump curves, inspection and repair history, parts replaced, flow and pressure readings and energy use. Good records help you plan replacements, prove performance and support warranty or insurance claims.

When to ask for help

Electrical, well, backflow and chemigation rules vary by state and utility. Talk with the equipment manufacturer or dealer, your extension irrigation specialist, your NRCS or conservation district office, a licensed electrician and your electric utility before you install, modify or repair major equipment. The state directory lists agencies and resources in every state.

Frequently asked questions

What does a corner arm do?

It swings out from the end of the pivot in the corners and retracts along the sides, watering ground a plain circle misses.

Do end guns work well?

They add reach cheaply, but their pattern is less uniform and wind sensitive. They suit small gains better than large corners.

Can I irrigate only part of a circle?

Yes. Most controls allow sector settings, which is useful where roads, buildings or trees block part of the circle.

Related guides

More from the network

Farm news, humor and ranch life at farm.FM.