Irrigation Equipment Directory

How a Center Pivot Works

A center pivot is a pipe on towers that rotates around a fixed point, sprinkling a circle. Each tower drives itself, and the end tower sets the pace for all.

Why it matters

Knowing how a pivot works helps you diagnose uneven watering, set application depth and spot trouble early. Every setting, from percent timer to nozzle size, depends on a few geometry and flow facts.

Step by step

  1. Water enters at the pivot point, flows through the pipe and sprinkler drops, and sprays across the circle.
  2. Each tower has a drive motor and gearboxes, and an alignment switch starts or stops it to keep the line straight.
  3. The end tower moves at a set speed, controlled by a percent timer that sets run time per minute.
  4. Faster travel applies less depth, slower travel applies more, because the same flow covers area over a different time.
  5. Pressure and flow at the pivot point must stay constant, or application changes across the whole circle.

What good looks like

A well running pivot keeps a straight line, moves smoothly with no stuck towers, sprays an even pattern and applies the depth you set. Check these on every inspection.

Worked example

Illustrative: a 1,320 foot pivot covers about 125.7 acres, since pi times 1,320 squared over 43,560 is 125.7. The end tower travels 8,294 feet per circle. At 10 feet per minute that takes 829 minutes, 13.8 hours. At 800 gpm that applies about 0.19 inch per pass.

Common mistakes to avoid

  • Setting the percent timer without recalculating depth for current flow.
  • Letting alignment drift until the pipe bends or buckles.
  • Ignoring pressure changes at the pivot point from pump wear.
  • Assuming the outer end applies the same flow per foot as the inner spans.

Safety, legal and compliance notes

Pivots carry electrical power and move without warning. Lock out power before service, keep people clear of towers, and have a licensed electrician or pivot technician handle control panels and drive wiring.

What to record

Keep a dated equipment file: purchase date and cost, model and serial numbers, nozzle and sprinkler package charts, pump curves, inspection and repair history, parts replaced, flow and pressure readings and energy use. Good records help you plan replacements, prove performance and support warranty or insurance claims.

When to ask for help

Electrical, well, backflow and chemigation rules vary by state and utility. Talk with the equipment manufacturer or dealer, your extension irrigation specialist, your NRCS or conservation district office, a licensed electrician and your electric utility before you install, modify or repair major equipment. The state directory lists agencies and resources in every state.

Frequently asked questions

What does the percent timer do?

It runs the end tower for a share of each minute. Lower percent means slower travel, so more water per pass.

Why do pivots wiggle?

Alignment switches start towers one at a time as they fall behind. A small stagger is normal, but a large bend means a fault.

Does the pivot cover the whole field?

Not in square fields. A circle leaves corners uncovered, which is why some farms add corner arms or end guns.

Related guides

More from the network

Farm news, humor and ranch life at farm.FM.