Water Source and Capacity Check
Before buying equipment, confirm your water source can deliver the flow your crop will demand during peak weeks. This check compares supply in gpm against required gpm.
Why it matters
Many systems fail because the source cannot keep up in July, even when it looked fine in spring. Pumping a well dry or drawing a pond down damages equipment and crops, and fixing it later costs far more.
Step by step
- Find peak daily crop use in inches per day, and divide by expected system efficiency to get gross inches per day.
- Multiply gross inches by acres to get acre-inches per day, then by 27,154 for gallons per day.
- Divide gallons per day by pumping minutes per day to get required continuous gpm.
- Measure supply with a long pumping test in the hot season, watching pumping level, flow and sand.
- Compare supply to demand, and keep a margin for drought years, pump wear and falling water levels.
What good looks like
A good result shows tested supply above required flow with a margin, stable pumping levels through the test, and clear water. If the margin is thin, plan a smaller irrigated area.
Worked example
Illustrative: 80 acres, peak use 0.28 inch per day, 80 percent efficiency. Gross use is 0.35 inch, so 28 acre-inches per day, or 760,312 gallons. Over 1,440 minutes that is about 528 gpm. A well testing 600 gpm gives 88 percent use and a 72 gpm margin.
Common mistakes to avoid
- Testing the well in spring when water levels are highest.
- Planning to pump 24 hours a day with no downtime allowance.
- Ignoring neighbors' pumping that can lower levels during the same weeks.
- Assuming yield from a short test lasts for a full season.
Safety, legal and compliance notes
Wells, ponds and diversions usually need permits, and limits on pumping vary. Contact your state water agency or local water district, and use a licensed well driller for testing and repairs.
What to record
Keep a dated equipment file: purchase date and cost, model and serial numbers, nozzle and sprinkler package charts, pump curves, inspection and repair history, parts replaced, flow and pressure readings and energy use. Good records help you plan replacements, prove performance and support warranty or insurance claims.
When to ask for help
Electrical, well, backflow and chemigation rules vary by state and utility. Talk with the equipment manufacturer or dealer, your extension irrigation specialist, your NRCS or conservation district office, a licensed electrician and your electric utility before you install, modify or repair major equipment. The state directory lists agencies and resources in every state.
Frequently asked questions
How long should a pumping test run?
Long enough for the water level to stabilize, often many hours to days. A well driller can set the length for your aquifer.
What if supply falls short?
Reduce irrigated acres, add storage, use more efficient application or choose drought tolerant crops. Do not oversize the system hoping supply improves.
Do I need a margin?
Yes. Supply can drop in dry years and pumps wear, so a margin of at least ten percent protects you from shortfalls.
Related guides
- Choosing an Irrigation System
- Irrigation System Cost Comparison Worksheet
- Irrigation Terms Explained
- Matching Equipment to Crop and Soil
- How a Center Pivot Works
- Pivot Sprinkler Package Basics
More from the network
Farm news, humor and ranch life at farm.FM.