Drip System Winter and Spring Care
Drip systems hold water in thin tubing, filters and fittings that freeze, crack and plug easily. A short end-of-season shutdown and a careful spring restart protect your investment and keep every emitter delivering its design flow.
Why it matters
Freeze damage and trapped debris are quiet problems. Cracked fittings and plugged emitters often go unnoticed until plants show stress in summer. Winter care takes a few hours, while repairs in July mean lost yield and hand-watering.
Step by step
- Flush every mainline, submain and lateral end in fall until the water runs clear, then close the ends.
- Drain filters, pressure regulators and valves, remove drain plugs, and open low point drains so no water stays trapped.
- Store exposed filter housings, gauges, injectors and controllers indoors, and cap open pipe ends against rodents and insects.
- In spring, fill the system slowly, flush mains first, then laterals, and only afterward close the lateral ends.
- Measure each zone's flow and inlet pressure, compare with your saved baseline, and record any zone that has drifted.
What good looks like
A good restart shows clear flush water, steady pressure at the zone inlet, no wet spots along the tubing, and zone flow within about 10 percent of the design figure recorded when the system was new.
Worked example
Illustrative zone: 1,200 emitters at 0.5 gallon per hour deliver 1,200 times 0.5, or 600 gallons per hour. Divide by 60 and design flow is 10 gallons per minute. In spring you measure 8.5 gallons per minute, which is 85 percent of design. That is below the 90 percent target, so flush the laterals again, clean the filter and inspect for plugged emitters before irrigating.
Common mistakes to avoid
- Leaving water in low spots, filter bowls and regulators that crack in freezes.
- Closing lateral ends before flushing, which locks sediment inside the lines for the season.
- Filling the system at full flow, which slams air through pipes and damages fittings.
- Skipping a flow check, so slow emitter plugging goes unseen until plants wilt.
Safety, legal and compliance notes
Chemical injection, backflow protection and any work near electrical panels or pressurized lines have legal and safety requirements. Ask a licensed irrigation or electrical professional and your local water agency before changing them.
What to record
Keep a dated equipment file: purchase date and cost, model and serial numbers, nozzle and sprinkler package charts, pump curves, inspection and repair history, parts replaced, flow and pressure readings and energy use. Good records help you plan replacements, prove performance and support warranty or insurance claims.
When to ask for help
Electrical, well, backflow and chemigation rules vary by state and utility. Talk with the equipment manufacturer or dealer, your extension irrigation specialist, your NRCS or conservation district office, a licensed electrician and your electric utility before you install, modify or repair major equipment. The state directory lists agencies and resources in every state.
Frequently asked questions
How often should I flush drip laterals?
Flush at least at the start and end of each season, and more often with poor quality water. Watch flush water clarity and pressure trends to decide.
Can I leave drip tubing in the field over winter?
Often yes, if it is fully drained and the ends are capped. Check for rodent damage and UV wear, and pick up any sections that look brittle.
What flow loss means I should act?
A drop of more than about 10 percent below your recorded baseline flow in a zone is a good signal to flush, clean filters and look for plugging.
Related guides
- Drip Irrigation System Basics
- Drip Tape vs Drip Line
- Drip Zone and Flow Design Worksheet
- Micro-Sprinklers and Emitters Compared
- How Irrigation Pumps Work
- Pump Selection Basics
More from the network
Farm news, humor and ranch life at farm.FM.