Irrigation Equipment Directory

Pump Selection Basics

Selecting a pump means defining two numbers first, the flow you need and the total head you must overcome. Then you compare pump types, curves, motors and power, so the machine fits your field.

Why it matters

A pump that is too small starves the field at peak crop use, and one that is too large burns energy and wears out early. A few minutes of arithmetic before buying prevents years of paying for the wrong duty point.

Step by step

  1. Calculate required flow from irrigated acres, peak daily water use in inches, and the hours per day you can pump.
  2. Total the head: lift, friction in mainline and fittings, elevation change, and pressure needed at the system.
  3. Ask suppliers for performance curves, and pick a model whose best efficiency range includes your flow and head point.
  4. Choose the power source by comparing line availability, installation cost, fuel logistics and expected annual running hours.
  5. Add a margin for future wear and falling water levels, and check suction conditions so the pump will not cavitate.

What good looks like

A good selection puts the duty point near peak efficiency, leaves a modest margin for wear, fits the available power and motor size, and has a documented total head calculation that someone else could check.

Worked example

Illustrative case: 40 acres, peak use 0.25 inch per day, 20 hours of pumping per day. Volume is 40 times 0.25, or 10 acre-inches per day. Divide by 20 hours to get 0.5 acre-inch per hour. One acre-inch per hour is about 453 gallons per minute, so you need roughly 0.5 times 453, or about 227 gallons per minute at the duty point, before adding any margin.

Common mistakes to avoid

  • Sizing the pump for average use instead of the peak crop water demand.
  • Forgetting friction loss in long mainlines, which can add many feet of head.
  • Selecting from the curve's far end where efficiency is poor and wear is high.
  • Ignoring how pumping hours per day change the flow you actually need.

Safety, legal and compliance notes

Well, pump and power installations may require permits, inspections and licensed contractors. Confirm requirements with your local water agency, electrical utility and a licensed pump or electrical professional before purchase.

What to record

Keep a dated equipment file: purchase date and cost, model and serial numbers, nozzle and sprinkler package charts, pump curves, inspection and repair history, parts replaced, flow and pressure readings and energy use. Good records help you plan replacements, prove performance and support warranty or insurance claims.

When to ask for help

Electrical, well, backflow and chemigation rules vary by state and utility. Talk with the equipment manufacturer or dealer, your extension irrigation specialist, your NRCS or conservation district office, a licensed electrician and your electric utility before you install, modify or repair major equipment. The state directory lists agencies and resources in every state.

Frequently asked questions

How much margin should I add to flow?

Many designers add a modest cushion, roughly 5 to 15 percent, for wear and future changes. Avoid large margins because they push the pump off its efficient range.

Should I buy based on horsepower?

No. Horsepower is an outcome, not a requirement. Select by flow and head first, then size the motor to the pump's power demand across its operating range.

Do I need a variable speed drive?

Only if flow or pressure needs vary a lot during the season. A drive can save energy in those cases but adds cost and needs a qualified installer.

Related guides

More from the network

Farm news, humor and ranch life at farm.FM.