Irrigation Equipment Directory

How Irrigation Pumps Work

Most irrigation pumps are centrifugal or vertical turbine machines. A motor spins impellers that throw water outward, turning speed into pressure. The pump does not make water, it adds energy so water can lift, travel and spray.

Why it matters

Understanding head, flow and efficiency lets you spot a mismatched pump before it wastes money. Every foot of lift, every pipe friction loss and every psi at the nozzle must be paid for by the pump and motor.

Step by step

  1. Define flow in gallons per minute, which is how much water the system must receive during its pumping hours.
  2. Add total head: lift from the water level, pipe and fitting friction loss, and the pressure the sprinkler needs.
  3. Convert pressure to feet of head by multiplying psi by 2.31, so all parts of the total share one unit.
  4. Plot flow and total head on the pump curve, and note where the point sits against best efficiency.
  5. Confirm the motor can carry the pump's power demand across its whole operating range, not just at the design point.

What good looks like

A well matched pump runs near the middle of its curve, holds steady pressure, makes no cavitation noise, and draws amps near but below the motor's rated figure at the working flow.

Worked example

Illustrative case: pumping lift 40 feet, friction loss 10 feet, and 30 psi needed at the system. Convert pressure to head by multiplying psi by 2.31: 30 times 2.31 equals 69.3 feet. Total head is 40 plus 69.3 plus 10, which equals 119.3 feet. Check by converting back: 119.3 divided by 2.31 is about 51.6 psi of pressure the pump must create.

Common mistakes to avoid

  • Sizing only for flow and forgetting that lift and friction add pump work.
  • Mixing psi and feet of head in one sum without converting between them.
  • Choosing an oversized pump that runs far left of its best efficiency range.
  • Ignoring falling water levels that raise lift late in the season.

Safety, legal and compliance notes

Pumps, couplings and motors can injure or kill. Lock out power before touching any rotating part, and leave motor, panel and wiring work to a licensed electrician or qualified pump service professional.

What to record

Keep a dated equipment file: purchase date and cost, model and serial numbers, nozzle and sprinkler package charts, pump curves, inspection and repair history, parts replaced, flow and pressure readings and energy use. Good records help you plan replacements, prove performance and support warranty or insurance claims.

When to ask for help

Electrical, well, backflow and chemigation rules vary by state and utility. Talk with the equipment manufacturer or dealer, your extension irrigation specialist, your NRCS or conservation district office, a licensed electrician and your electric utility before you install, modify or repair major equipment. The state directory lists agencies and resources in every state.

Frequently asked questions

What is the difference between a centrifugal and a turbine pump?

A centrifugal pump sits at the surface and pulls water in. A vertical turbine places its impellers below the water level and pushes water up a column.

Why does a pump make noise like gravel?

That sound is usually cavitation, caused by too little suction pressure or a restricted inlet. It damages impellers, so find the cause and correct it quickly.

Does a bigger pump always give more water?

No. Output depends on the whole system curve. A bigger pump can raise pressure and energy use without adding useful flow, and it may overload the motor.

Related guides

More from the network

Farm news, humor and ranch life at farm.FM.