Drip System Flushing Routine
Flushing sweeps silt and slime out of drip lines before it plugs emitters. Done in a set order with enough velocity, it is one of the cheapest steps in drip care.
Why it matters
Particles that pass the filter settle at line ends, build up and clog emitters from the end backward. Routine flushing removes them early, protecting uniformity and stretching the life of tubing.
Step by step
- Flush the filters first, following their cleaning cycle, so the water sent downstream is as clean as possible.
- Flush mainlines next by opening the far end valves until the water runs clear.
- Flush submains, then open the lateral ends zone by zone, keeping pressure up for fast flow.
- Close the lateral ends one section at a time, only after the water runs clear.
- Log the date, zone, how long water ran dirty and any repairs, then repeat on a set schedule.
What good looks like
A good routine ends with clear water at every line end, consistent pressure afterward, and a log showing flush dates and how long water stayed dirty. Dirtier flushes call for more frequent flushing.
Worked example
Illustrative: a lateral with 0.875 inch inside diameter has 0.601 square inch of area, or 0.004175 square foot. At 1 foot per second, flow is 0.004175 times 448.8, about 1.87 gpm. Forty laterals need 75 gpm, so a 150 gpm supply opens about 80 lines at once.
Common mistakes to avoid
- Flushing laterals without flushing mainlines and submains first.
- Closing line ends before the water runs clear.
- Opening too many ends at once, so velocity drops and dirt stays.
- Flushing only at the season start and never again.
Safety, legal and compliance notes
Flush water carries sediment and any injected materials. Direct it so it does not enter streams or ditches, follow local rules for discharge, and consult your local conservation office if unsure.
What to record
Keep a dated equipment file: purchase date and cost, model and serial numbers, nozzle and sprinkler package charts, pump curves, inspection and repair history, parts replaced, flow and pressure readings and energy use. Good records help you plan replacements, prove performance and support warranty or insurance claims.
When to ask for help
Electrical, well, backflow and chemigation rules vary by state and utility. Talk with the equipment manufacturer or dealer, your extension irrigation specialist, your NRCS or conservation district office, a licensed electrician and your electric utility before you install, modify or repair major equipment. The state directory lists agencies and resources in every state.
Frequently asked questions
How often should I flush?
Set the schedule from your water quality. Dirty or algae prone sources may need flushing weekly, while clean sources may need it monthly.
What velocity should I aim for?
A common target is about 1 foot per second in lateral ends. Check manufacturer guidance for your tubing.
Does flushing waste much water?
Only a little compared with irrigation, and it avoids clogging that wastes far more through poor uniformity.
Related guides
- Drip Irrigation System Basics
- Drip Tape vs Drip Line
- Drip Zone and Flow Design Worksheet
- Micro-Sprinklers and Emitters Compared
- How Irrigation Pumps Work
- Pump Selection Basics
More from the network
Farm news, humor and ranch life at farm.FM.