Well Output and Drawdown Basics
A well's output depends on how much its water level falls as you pump. Static level is the resting depth, pumping level is the depth while running, and the difference is drawdown. These show what the well can supply.
Why it matters
Pumping a well beyond its capacity lowers the water level toward the pump intake, which causes air in the water, sand, damage and burnout. Knowing drawdown lets you size the pump to the well and plan for dry seasons.
Step by step
- Measure static water level in feet from the ground after the pump has been off for several hours.
- Run the pump at steady flow for a long test, and measure the pumping level and flow near the end.
- Subtract static level from pumping level to get drawdown in feet, and note the flow used.
- Divide flow by drawdown to get specific capacity in gallons per minute per foot of drawdown.
- Repeat the test each year in the same season, and compare it with earlier results to spot declining performance.
What good looks like
A healthy well shows steady specific capacity from year to year, a pumping level comfortably above the pump intake, clear water without sand, and recovery to near the static level after shutdown.
Worked example
Illustrative test: static level 60 feet, pumping level 95 feet at 420 gpm. Drawdown is 95 minus 60, or 35 feet, so specific capacity is 420 divided by 35, or 12 gpm per foot. If that holds at 600 gpm, drawdown would be 600 divided by 12, or 50 feet, giving a pumping level of 110 feet. Keep the pump intake well below that, with margin.
Common mistakes to avoid
- Taking a pumping level reading before the water level has stabilized.
- Assuming specific capacity stays constant at much higher flows, when it usually falls.
- Setting the pump intake too close to the expected pumping level.
- Measuring static level right after shutdown, before the well has recovered.
Safety, legal and compliance notes
Well construction, testing, water level reporting and pumping limits are regulated and differ by area. Contact your water agency and a licensed well driller or hydrogeologist before changing a well or its output.
What to record
Keep a dated equipment file: purchase date and cost, model and serial numbers, nozzle and sprinkler package charts, pump curves, inspection and repair history, parts replaced, flow and pressure readings and energy use. Good records help you plan replacements, prove performance and support warranty or insurance claims.
When to ask for help
Electrical, well, backflow and chemigation rules vary by state and utility. Talk with the equipment manufacturer or dealer, your extension irrigation specialist, your NRCS or conservation district office, a licensed electrician and your electric utility before you install, modify or repair major equipment. The state directory lists agencies and resources in every state.
Frequently asked questions
How long should a well test run?
Long enough for the pumping level to stabilize, often several hours or more. Your well driller can recommend a test length that suits your aquifer.
What causes specific capacity to decline?
Common causes include a falling regional water level, screen plugging, pump wear and well casing problems. A professional inspection can narrow down the cause.
Can I pump a well continuously?
Only if drawdown stays stable and the pumping level stays well above the intake. Continuous pumping can harm a weak well, so follow test results and local rules.
Related guides
- How Irrigation Pumps Work
- Pump Selection Basics
- Pump Efficiency and Energy Cost Worksheet
- Electric vs Diesel Irrigation Power
- Irrigation Filtration Basics
- Choosing a Filter Type
More from the network
Farm news, humor and ranch life at farm.FM.