Irrigation Equipment Directory

Pump Efficiency and Energy Cost Worksheet

This worksheet turns three field measurements, flow, total head and electric input, into pump efficiency and cost per acre-inch. Fill in each line in order, and you will see whether your pumping plant is earning its power bill.

Why it matters

Pumping is often the largest ongoing irrigation cost. A plant running at low efficiency pays for power that never becomes water movement. A yearly worksheet shows when repair, rewinding or replacement is cheaper than continued waste.

Step by step

  1. Lines 1 and 2: record flow in gallons per minute from a meter, and total head in feet.
  2. Line 3: compute water horsepower as flow in gpm times head in feet divided by the constant 3,960.
  3. Line 4: read input kilowatts from the meter or amps and volts, then convert to horsepower by dividing by 0.746.
  4. Lines 5 and 6: divide water horsepower by input horsepower for efficiency, and multiply input kilowatts by your rate.
  5. Line 7: convert flow to acre-inches per hour by dividing by 453, then divide hourly cost by that figure.

What good looks like

A good result is an efficiency figure near the range expected for your pump type and size, a cost per acre-inch that stays steady year to year, and a dated record that lets you spot decline.

Worked example

Illustrative sample: 500 gpm and 150 feet give 75,000 divided by 3,960, which is 18.9 water horsepower. At 65 percent efficiency, input is 18.9 divided by 0.65, or 29.1 horsepower, which is 21.7 kilowatts. At an illustrative 10 cents per kWh that costs $2.17 per hour. Flow is 500 divided by 453, or 1.10 acre-inches per hour, so cost is about $1.97 per acre-inch.

Common mistakes to avoid

  • Measuring head at the pump instead of from pumping water level to discharge.
  • Using nameplate motor horsepower instead of measured input power at the meter.
  • Reading pressure with a worn or uncalibrated gauge, which skews head and efficiency.
  • Testing once and never repeating, so slow wear in the pump goes unnoticed.

Safety, legal and compliance notes

Electrical measurements involve live conductors. Have a licensed electrician take amp and voltage readings, and ask your power supplier about metering questions. Use general figures here only as a guide.

What to record

Keep a dated equipment file: purchase date and cost, model and serial numbers, nozzle and sprinkler package charts, pump curves, inspection and repair history, parts replaced, flow and pressure readings and energy use. Good records help you plan replacements, prove performance and support warranty or insurance claims.

When to ask for help

Electrical, well, backflow and chemigation rules vary by state and utility. Talk with the equipment manufacturer or dealer, your extension irrigation specialist, your NRCS or conservation district office, a licensed electrician and your electric utility before you install, modify or repair major equipment. The state directory lists agencies and resources in every state.

Frequently asked questions

Where do I get flow for the worksheet?

Use a flow meter on the discharge line, or a timed reading of a totalizer. Estimates from nozzle charts are less reliable than a direct meter reading.

What if my efficiency looks low?

Check the measurements first, then look at impeller wear, clearances, suction conditions and motor condition. A pump tester or service professional can confirm and quote repair against replacement.

How often should I run the worksheet?

Run it at least once a year at the same operating point, and again after any repair, so results are comparable from one season to the next.

Related guides

More from the network

Farm news, humor and ranch life at farm.FM.