Irrigation Equipment Directory

Irrigation Filtration Basics

Filtration removes sand, silt, algae and organic matter before they plug emitters, nozzles and valves. The filter you need depends on your water source, the smallest opening in your system and your flow rate.

Why it matters

Drip emitters and microsprays have tiny passages. One bad season of unfiltered or poorly filtered water can plug them permanently. A properly matched filter protects equipment far more cheaply than replacing whole lines of tubing and emitters.

Step by step

  1. Test your water source for suspended solids, algae, iron and sand, since each type of contaminant calls for different treatment.
  2. Find the smallest passage in your system, usually the drip emitter, and note its size in millimeters or microns.
  3. Pick a filter opening of roughly one-seventh to one-tenth of that passage size, a common rule of thumb.
  4. Size the filter housing for your maximum flow with some margin, so velocity stays within its design range.
  5. Record clean pressure drop across the filter, and clean or flush it when the drop rises by a set amount.

What good looks like

A well run filtration setup holds a stable pressure drop between cleanings, delivers clear water downstream, flushes automatically or on schedule, and shows no emitter plugging anywhere in the field.

Worked example

Illustrative case: the smallest emitter opening is 0.8 mm, which is 800 microns. One-seventh is about 114 microns and one-tenth is 80 microns. A filter in the 80 to 115 micron range, roughly 150 mesh, would suit. Clean pressure drop is 3 psi; if you flush when the drop rises 5 psi, that happens at 8 psi across the filter, so mark that gauge reading.

Common mistakes to avoid

  • Choosing a filter by mesh number alone without matching it to emitter opening size.
  • Oversizing the opening so the filter passes particles that plug emitters.
  • Ignoring pressure drop, so a clogged filter starves the field unnoticed.
  • Cleaning on the calendar only, without watching how quickly the filter loads.

Safety, legal and compliance notes

Water quality, chemical injection and backflow prevention may be regulated. Ask your local water agency, extension office and a certified irrigation professional about requirements before changing treatment or connections.

What to record

Keep a dated equipment file: purchase date and cost, model and serial numbers, nozzle and sprinkler package charts, pump curves, inspection and repair history, parts replaced, flow and pressure readings and energy use. Good records help you plan replacements, prove performance and support warranty or insurance claims.

When to ask for help

Electrical, well, backflow and chemigation rules vary by state and utility. Talk with the equipment manufacturer or dealer, your extension irrigation specialist, your NRCS or conservation district office, a licensed electrician and your electric utility before you install, modify or repair major equipment. The state directory lists agencies and resources in every state.

Frequently asked questions

What does mesh number mean?

Mesh counts openings per inch, so a higher number means finer openings. Compare mesh to microns with a chart, then match it to your emitter passage size.

How often should I clean a filter?

Clean when pressure drop rises by a set amount over your clean baseline, often 5 to 10 psi. Poor quality water may need cleaning daily.

Is one filter enough for all sources?

Not always. Heavy sand, algae or organic loads often need more than one stage, such as a pre-filter ahead of a fine filter.

Related guides

More from the network

Farm news, humor and ranch life at farm.FM.