Irrigation Equipment Directory

Soil Moisture Sensor Basics

Soil moisture sensors estimate how much water the soil holds, either as a percent of volume or as suction tension. Used well, they show when the crop root zone is drying out and whether an irrigation reached the roots.

Why it matters

Sensors turn guessing into evidence, but only when placed well and interpreted against your soil. A sensor in the wrong spot, or read without reference points, can mislead you into irrigating too early or too late.

Step by step

  1. Pick representative spots in the field, away from wet corners, headlands and compacted wheel tracks, and mark them for later.
  2. Install sensors at upper and lower root depths in firm contact with the soil, leaving no air gaps.
  3. Record the readings at field capacity after a thorough irrigation, and at the dry limit for your crop and soil.
  4. Set a trigger reading by choosing how much of the available water the crop may use before irrigating.
  5. Confirm sensor readings against a hand soil probe or shovel check several times per season.

What good looks like

Good use shows readings that rise after irrigation, fall steadily as the crop uses water, and trigger irrigation before stress. The lower sensor confirms water reached the deeper roots without leaching below.

Worked example

Illustrative soil: field capacity reads 30 percent and the dry limit reads 14 percent, so available water is 16 points. Allowing 50 percent depletion means irrigating when the reading falls by 8 points, to 30 minus 8, or 22 percent. Across a 12 inch layer, 8 points is 0.08 times 12, or 0.96 inch of water used, which is the amount your next irrigation must replace.

Common mistakes to avoid

  • Placing one sensor and treating it as the whole field's condition.
  • Using readings without finding field capacity and dry limit for that soil.
  • Installing with air gaps around the probe, which gives false dry readings.
  • Never checking sensors against a hand probe, so drift goes unnoticed.

Safety, legal and compliance notes

Sensor wiring, telemetry and power equipment may involve electrical work. Use a qualified installer for anything beyond simple battery units, and check with an extension agent for local calibration guidance.

What to record

Keep a dated equipment file: purchase date and cost, model and serial numbers, nozzle and sprinkler package charts, pump curves, inspection and repair history, parts replaced, flow and pressure readings and energy use. Good records help you plan replacements, prove performance and support warranty or insurance claims.

When to ask for help

Electrical, well, backflow and chemigation rules vary by state and utility. Talk with the equipment manufacturer or dealer, your extension irrigation specialist, your NRCS or conservation district office, a licensed electrician and your electric utility before you install, modify or repair major equipment. The state directory lists agencies and resources in every state.

Frequently asked questions

How many sensors do I need per field?

Start with at least two or three locations that represent main soil types, each with more than one depth. More locations help in variable fields.

Do sensors replace checking the soil?

No. Sensors support your judgment and need periodic checks with a probe or shovel. Calibration and placement matter more than the number of sensors.

Why do my readings jump after rain?

Rain wets the upper layers fast, so shallow sensors rise first. Watch the deeper sensors to see how far the water moved into the root zone.

Related guides

More from the network

Farm news, humor and ranch life at farm.FM.