Irrigation Equipment Directory

Winterizing Irrigation Equipment

Winterizing removes water from pipes, pumps, filters, valves and fittings before it freezes and expands. A few hours of draining and protecting parts in fall prevents cracked housings, split pipe and burst fittings.

Why it matters

Water expands as it freezes and can split pipe, crack pump housings and wreck valves. Damage often stays hidden until spring pressurizing, when repairs are urgent, expensive and delay the first irrigation of the season.

Step by step

  1. Shut off power, close the water source, and relieve all pressure in mainlines and laterals before opening any fittings.
  2. Open low point drains and drain plugs, and drain pumps, filters, regulators and injection equipment completely.
  3. Blow out lines zone by zone with low pressure air, only when the system is rated for it.
  4. Remove gauges, controllers, sensors and small valve parts that cannot be drained, and store them somewhere dry and warm.
  5. Cap open pipe ends, seal enclosures against rodents, and tag a winterizing record listing what you drained and removed.

What good looks like

A well winterized system has no standing water at any low point, caps and covers in place, delicate parts stored indoors, and a written list that makes spring startup quick.

Worked example

Illustrative case: 1,000 feet of 4 inch pipe holds about 0.653 gallon per foot, or 653 gallons. Water gains roughly 9 percent in volume on freezing, so 653 times 0.09 is about 59 gallons of extra volume with nowhere to go inside the pipe. Draining low points before the first hard freeze costs minutes, while hoping costs split pipe and a delayed first irrigation.

Common mistakes to avoid

  • Draining only at the pump and leaving trapped water in low spots along pipe.
  • Using air at too high a pressure and bursting lines or fittings.
  • Leaving gauges, sensors and controller boards outside where they freeze solid.
  • Skipping the written winterizing record, so spring crews repeat or miss steps.

Safety, legal and compliance notes

Compressed air and pressurized pipe can cause serious injury. Wear eye protection, stay within pipe pressure ratings, and ask a qualified irrigation professional about safe blowout procedures for your system.

What to record

Keep a dated equipment file: purchase date and cost, model and serial numbers, nozzle and sprinkler package charts, pump curves, inspection and repair history, parts replaced, flow and pressure readings and energy use. Good records help you plan replacements, prove performance and support warranty or insurance claims.

When to ask for help

Electrical, well, backflow and chemigation rules vary by state and utility. Talk with the equipment manufacturer or dealer, your extension irrigation specialist, your NRCS or conservation district office, a licensed electrician and your electric utility before you install, modify or repair major equipment. The state directory lists agencies and resources in every state.

Frequently asked questions

Is blowing out lines always needed?

Not always. Systems with enough slope and open low point drains may drain by gravity. Check your design, and use air only where it is appropriate.

When should I winterize?

Do it before the first hard freeze is likely in your area. Local weather records and your extension office can help you pick a safe window.

Can I leave a pump outside over winter?

Only if it is fully drained, protected from weather and rodents, and its maker allows it. Many growers store small parts indoors for added safety.

Related guides

More from the network

Farm news, humor and ranch life at farm.FM.