Irrigation Controllers and Timers
A controller opens and closes valves or starts pumps on a schedule. Timers are simple clock based devices, while smarter controllers can adjust run times using weather, sensors or remote commands from a phone or computer.
Why it matters
Controllers do exactly what you tell them, including watering through a storm or running too long. Correct programming, tested with real measurements, saves water and labor, while one bad setting wastes both every single night.
Step by step
- Find each zone's application rate in inches per hour from a catch can test or from system design data.
- Decide the net depth to apply, then divide by system efficiency as a decimal to get the gross depth.
- Divide gross depth by application rate to get run time, and enter it for that zone.
- Stagger start times so the total flow of zones running together stays within pump and pipe capacity.
- Add a rain delay or sensor input, and check the program once a month against actual conditions.
What good looks like
A good program applies the intended depth in each zone, never overloads the pump, stops when it rains, and has a written record of settings that anyone could follow when you are away.
Worked example
Illustrative zone: application rate is 0.40 inch per hour and net need is 0.60 inch at 75 percent efficiency. Gross depth is 0.60 divided by 0.75, or 0.80 inch. Run time is 0.80 divided by 0.40, which equals 2 hours. If three zones each need 90 gpm, together they need 270 gpm, so a 200 gpm supply can run only two zones at once.
Common mistakes to avoid
- Programming run times from guesswork instead of measured application rates.
- Starting every zone at once and exceeding the pump's capacity.
- Leaving a seasonal adjustment untouched while crop water use changes.
- Failing to back up settings, so a power loss resets the program.
Safety, legal and compliance notes
Controllers connect to power and may control pumps and chemical injectors. Electrical installation, surge protection and chemigation interlocks should be handled by a licensed electrician and a certified irrigation professional.
What to record
Keep a dated equipment file: purchase date and cost, model and serial numbers, nozzle and sprinkler package charts, pump curves, inspection and repair history, parts replaced, flow and pressure readings and energy use. Good records help you plan replacements, prove performance and support warranty or insurance claims.
When to ask for help
Electrical, well, backflow and chemigation rules vary by state and utility. Talk with the equipment manufacturer or dealer, your extension irrigation specialist, your NRCS or conservation district office, a licensed electrician and your electric utility before you install, modify or repair major equipment. The state directory lists agencies and resources in every state.
Frequently asked questions
Do I need a smart controller?
Not always. A basic timer works for stable schedules. Smart controllers help when weather or crop demand varies and you value remote changes or logging.
How do I check my programmed run time?
Observe a full cycle, then measure applied depth with catch cans or a flow meter reading. Compare the result with the depth you intended to apply.
What happens in a power outage?
Many controllers keep settings with a backup battery, but some lose their clock. Check the controller after any outage and restart schedules as needed.
Related guides
- Irrigation Filtration Basics
- Choosing a Filter Type
- Soil Moisture Sensor Basics
- Pressure and Flow Monitoring
- Irrigation Maintenance Calendar
- Winterizing Irrigation Equipment
More from the network
Farm news, humor and ranch life at farm.FM.