Irrigation Equipment Directory

Spring Startup Checklist for Irrigation

This checklist takes you from a dormant system to a tested, running one. Following the sequence, inspect, fill slowly, flush, test and record, finds winter damage while it is cheap to fix and before crops need water.

Why it matters

Starting a system at full pressure after winter can turn small cracks into blowouts and send trapped debris into filters and emitters. A careful startup finds problems early and gives you a fresh baseline for the season.

Step by step

  1. Inspect pipe, fittings, pumps, motors, guards and wiring for rodent, weather or freeze damage, and replace anything suspect first.
  2. Reinstall gauges, sensors, controllers and drain plugs, close all low point drains, and confirm valves are in their starting positions.
  3. Fill mainlines slowly with air release open, then raise pressure in small steps while checking for leaks.
  4. Flush mains, submains and laterals until water runs clear, clean filters, and close the flush ends and open zone valves.
  5. Run each zone, record pressure and flow, and fix any zone more than about 10 percent off last year's baseline.

What good looks like

A good startup finishes with no leaks, every zone operating at baseline pressure and flow, clean filters, controllers programmed, and a signed checklist kept as this season's starting reference for later comparison.

Worked example

Illustrative fill: 1,000 feet of 4 inch line holds about 653 gallons, from 1,000 times 0.653 gallon per foot. Filling at 20 gpm takes 653 divided by 20, or about 33 minutes. At 100 gpm the same line would fill in about 6.5 minutes, but that fast rate traps air. The slow rate gives air time to escape and avoids sudden pressure surges.

Common mistakes to avoid

  • Filling at full flow, which traps air and causes pressure surges and damage.
  • Closing flush ends before the water runs clear, leaving debris in laterals.
  • Programming controllers before testing valves and finding that a zone does not open.
  • Skipping baseline readings, which removes the comparison for later problems.

Safety, legal and compliance notes

Energizing pumps, controllers and chemical injection systems involves electrical and pressure hazards. Have a licensed electrician and certified irrigation professional review any equipment you are not qualified to start safely.

What to record

Keep a dated equipment file: purchase date and cost, model and serial numbers, nozzle and sprinkler package charts, pump curves, inspection and repair history, parts replaced, flow and pressure readings and energy use. Good records help you plan replacements, prove performance and support warranty or insurance claims.

When to ask for help

Electrical, well, backflow and chemigation rules vary by state and utility. Talk with the equipment manufacturer or dealer, your extension irrigation specialist, your NRCS or conservation district office, a licensed electrician and your electric utility before you install, modify or repair major equipment. The state directory lists agencies and resources in every state.

Frequently asked questions

What should I check first in spring?

Start with a visual inspection for damage, then confirm power is locked out while you work. Fill the system only after repairs and reassembly are finished.

How long should I flush lines?

Flush each line until water runs clear and pressure holds steady. Dirty lines can take several minutes, so watch the water rather than the clock.

Do I need to recalibrate sensors in spring?

Yes, check them. Compare readings with a hand probe after the first irrigation, replace batteries, and note any drift from last season's results.

Related guides

More from the network

Farm news, humor and ranch life at farm.FM.